J3 Cleaning
1
FINISHED JUICING
When you’re finished juicing, always hand wash your juicer right away. Pull the entire chamber set off of the base and disassemble in the sink.
Note: Chamber set cannot be disassembled while still on the base.
2
WASH EACH COMPONENT
Twist open the hopper and disassemble the strainer set. Wash each component by running them under water and scrubbing with a sponge or brush. The cleaning brush comes with a dual-ended tip, which can be used to pick out any pulp or scrub smaller areas.
Note: Reference the manual for details on the silicon parts. We recommend removing them every once in a while and cleaning them with the included brush.
3
PULP OUTLET LOOP
When cleaning the chamber, open the pulp outlet loop and clean the inside. The pulp outlet gasket can be easily removed and cleaned. Once clean, simply push it back into place.
4
DRYING
Make sure to always hand dry your juicer right away after washing. This will prevent any remaining residue from staining your juicer. Leave it out to dry before reassembling.
Watch the full video
